![]() ![]() In my original DS414j comment, I have shown it is suitable as a backup NAS. However, units used for long-term testing have never performed an overheating exchange. The unit does not support hot swap, but we tried it and found it effective. However, for full disclosure, I should note that the unit was used in accordance with Synology's instructions and referenced the hot plug in the review process. This time, the web user interface was accessible, but they gave me a terrible message that there is no hard drive in the device.Īccording to its expected usage scenario, NAS has little load on network and disk traffic. On the left side of the other options, I pressed the power button on the front panel to turn off the device and reset it. The unit's web user interface is not accessible. The four hard disk indicators flash and the status light is orange. I woke up on Saturday morning and the recently commissioned Synology DS414j kept snoring. In two cases (one with Seagate Barracuda 1TB for NETGEAR NV+v2 and another with Samsung's Spinpoint for 1TB at QNAP TS-659 PRO II), User Interface NAS complained about increasing the number of reconfigured sectors on the disk On, I immediately back up the data and reinitialize the drive with the new drive. Although I have used RAID reconstruction as part of every NAS evaluation, I have never done it during normal use. ![]() After running more than 24x7 NAS devices for more than 4 years, I finally got into a situation where data availability was completely stopped. Recovering data from a Failed Synology NAS
0 Comments
Leave a Reply. |